Repair Distraction Actuator:
1. Start by test fitting the small piece in the end of the actuator to determine if it slides easily.
A. If so remove the small piece and apply Loctite 609 on the outside surface and reinsert.
B. If it doesn't slide easily, place the small piece in the freezer for 30 mins and test fit again and determine if it slides easily.
- If it slides easily, while still code remove the piece snd apply Lictite 609 and reinsert.
- If it doesn't slide easily, While still cold remove the piece sand apply Loctite 609 and reinsert by pressing it in using constant force. *not impact!