Skip to main content

Submit a request

Hill Laboratories
Product Support
Anatomotor

Articles in this section

Instructions for the New Cervical Traction Device
Adjusting variable speed on circuit board
Traction Control Unit- Calibration instructions
Adding lubricant to 924 gear box
How to tighten back roller spur gear
Back roller won't stay up
General maintenance
Adjusting the microswitch to stop at either end
Troubleshooting the top not stopping with a variable speed motor
Troubleshooting the table top will not move with a tilt top

See more

Adding lubricant to 924 gear box

March 16, 2021 17:24
Updated

Remove a fill/level plug. Add fluid until the level is visible.

Was this article helpful?

1 out of 1 found this helpful

Have more questions? Submit a request

Related articles

How to tighten back roller spur gear
General maintenance
Troubleshooting brake rectifier current overload fault
Anatomotor
Traction Control Unit- Calibration instructions

Go to HillLabs.com