- Unplug the table and remove air pressure from the system.
- Disconnect all air lines at the air regulator board (the "Kelly").
- The controller (the "Click") is mounted next to the Kelly on the din rail. It is a white enclosure with "Click" printed on the main face. Follow the wires from the side of the "Click" over to the power supply and disconnect only these two wires from the power supply. Remove the Kelly and the Click.
NOTE: Leave the power supply on the scissor. It is still needed to power the AutoFlex.
4. Remove the control box and the patient stop switch that are secured with screws to the underside of the cushions
5. To reconnect the air lines for standard distraction you need to locate the "Y" fitting shown in the photo and disconnect it, as shown, in order to remove that fitting and that section of air lines from the table.

6. Use a section of air hose just removed and insert one end into the brass "T" shown at the top of the manifold (before the filter). Insert the other end into the stand-alone coil located next to the manifold.